Volkwagen New Beetle . Timing Components Timing Belt

Vehicle: Exploded Views Timing Belt Toothed Belt 1. 25 Nm 2. Tensioning device for ribbed belt Turn with open-end spanner to loosen ribbed belt 3. Toothed belt guard - upper part 4. Toothed belt guard - center section 5. 27 Nm 6. Idler wheel 7. Tensioning roller 8. Toothed belt Mark direction of travel before removing Check for wear Do not kink Removing, installing and tensioning, refer to Service and Repair - Procedure See: Engine, Cooling and Exhaust/Engine/Timing Components/Timing Belt/Service and Repair 9. Coolant pump 10. 0-Ring Always replace if damaged

11. 15 Nm 12. Tensioner for toothed belt 13. Crankshaft toothed belt sprocket 14. 15 Nm 15. 20 Nm 16. 90 Nm + 1/4 turn (90°) further Always replace Counter-hold with 3099 to loosen and tighten When bolting on, place two washers between toothed belt pulley and counter-hold 17. Toothed belt guard - lower part 18. 10 Nm Insert with locking fluid D 000 600 A2 19. Pulley For power assisted steering pump 20. 25 Nm 21. Ribbed belt Mark direction of rotation before removing Removing and installing, refer to Engine, Cooling and Exhaust - Engine - Drive Belt, Mounts, Brackets and Accessories - Drive Belt - Service and Repair - Procedures See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair 22. 25 Nm 23. Belt - pulley/vibration damper Can only be installed in one position (holes are oftset) Note position when installing toothed belt